|
Now we "pull off" any sludge from the DA sanding (image 1) and finish off by lightly hand sanding with 180 grit paper and kissing the corner (image 2&3).
Now we make a trial fit (image 4) to insure that we have mostly full contact, and I suggest you tape the ring in place (image 4) place the lens over the ring (it will actually fit snugly so you can test fit the lamp to your bumper if you like. (image 5) Note image 4, you will need to notch the lens housing for the wire, I prefer to have the wire on the top of the lamp, I also insist that we get the lens back on with the lettering on the bottom, thus a stock factory look under close observation.
|