Quote:
Originally Posted by BLWN SS
Tom, I received mine today from SJM Mfg. He sells the Hurst kit for $245.00 and a kit with a different brand of solenoid for $175.00. I bought his-came ready to install with everything needed. Nice set up. Looks like about a 1-2 hour project.
|
You'll have to spend a little time bending the preformed tubes. Most of the work is deciding where you want wiring to run neatly. Ran mine through a 1" existing grommet that enters the bottom of the cabin air filter compartment (inside car you'll find it just above the carpet level behind insulation, viewable after removing the passenger right foot kick panel) and exiting the compartment with the supplied small grommet. I think Larry ran his there too.
__________________
LPE 650+,IOM Pearl White Rallys
860 RWHP 924 RWTQ,TVS2300 10/14 OD 2.75/NW 102mm,RDS/FLOWED "109" SHOT/LPE NCC
NLP spoiler/GM splitter/Torq HE-fans/oil coolers/IC1000cc
Squash twins,GT9,Coil Covers,Mats,Pedals/ADM Gauges,Race Scoop/Trunions
DDS CVs,Carbon F DS/RPM L6/LPE 9.5 3.73/Pedders HD bushes,align kit
RB 2-piece rotors,S/S Lines,Hawk HPE Pads/Forgeline SP3P/Weld RTS
Ceramic ARH 2" LT/3" X-pipe,Corsa Touring/BMR TA,Toe,LCA,DS Loop
StreetSlayer BC3/MTI Shifter-Trans mt/Hotchkis CB/Monster CC/SJM LineLock
PFADT Coil Overs,Sways,Links,Mounts,SF Bushes,Camber Kit
LPE Brotherhood
.
|