|
" Have the tech loosen every rotational bolt / bush in the suspension. Drive the car SLOWLY and CAREFULLY around the lot with the bolts a couple of turns loose. Put it back on the alignment lift. Without taking any weight off the wheels, tighten all the bolts. All the bushes are now timed to your new lowered ride height. "
I've looked at all the sellers of lowered springs instructions and no one mentions this step. I wonder just how many folks or install shops either drop spring or coil over users actually loosened every suspension point and recenter the bushings. I was well aware of this step but this thread seems to be the first to mention it is necessary.
Ed M.
__________________
RJT 2SS/RS, AAM 3.70's, MTI Sway Bars, Shifter, SS brake lines ZLI calipers, rotors/pads BMR Trailing & Toe Arms, rear cradle/diff bushes, Pedders XA's, Camber/Toe eccentrics, Radius arm inserts, GTO clutch reservoir, LS9 cam, Comp valve springs, Melling 10296 oil pump, CR5 timing chain, LS6 damper, CAI Cold Air Intake, ARH LT headers, HF cats, GMPP axle back, Elite Eng Catch Can, Black ZL1 20x10 & 2011 whls 285/35/20 & 305/35/20 General G-Max RS, 2011 Convertible spoiler, 1LE front spoiler, Lloyd "SS" Floor Mats, GM Camaro Trunk Mat, wrapped console, hand brake lever, Grant steering whl.
|