Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com - View Single Post

ackeight · 07-11-2010, 03:53 PM

This was the easiest bolt on to date that I've every done. Took 30 mins for EVERYTHING. I even took out the EVAP lines and sensors. The only thing I was dissapointed with is it didn't include the locking washer for the long stud to be screwed into the ground. Does anybody know what size it is? I'll probably pick one up at Lowes eventually and install it later. I'll give it about 900 miles when I change all my fluids to write up my review on it.

07-11-2010, 03:53 PM	#1
ackeight Drives: 10' 2SS/RS Join Date: Jan 2010 Location: Rockwall, TX Posts: 1,389	Elite Engineering Catch Can install This was the easiest bolt on to date that I've every done. Took 30 mins for EVERYTHING. I even took out the EVAP lines and sensors. The only thing I was dissapointed with is it didn't include the locking washer for the long stud to be screwed into the ground. Does anybody know what size it is? I'll probably pick one up at Lowes eventually and install it later. I'll give it about 900 miles when I change all my fluids to write up my review on it.