12-06-2008, 05:33 PM
|
#6
|
Drives: Aggressive
Join Date: Jul 2008
Location: Southampton, PA.
Posts: 1,086
|
Quote:
Originally Posted by YellrRS
I was at the auto show today in Boston, very disappointed as the car was surrounded by plexi glass keeping you from getting close. I wanted to sit in it, to see if it felt right, and get an up close look at the inside.
No go, its a friggin auto SHOW, guy said because the car isnt released yet, you could only stare from a distant, wish I had saved the twelve bucks, I have seen more here.
This is turning into quite a bit of aggravation at this point, some of the shine is wearing off, I have already put down a deposit, full of if's, and I dont know's, now were at the look but dont touch stage, geez its just a car isnt it? I sat in an 86k Corvette, but couldnt get near a 30k Camaro, what a drag.  |
Because they are not production intent yet. Fbodfather said middle of December is when actual production camaro's would be produced for auto shows. I think that's right? Anyone? Father?
__________________
Black 2SS RS LS3 Inferno Int. '17 1LE replica 20's {MODS} KOOKS LT: Borla S-Type: Roto-Fab CAI: Hurst ST.: PFADT Stage 2, Trailing arms, Tie Rods: ECS BigBlower Cam: Fast 102mm intake: Brian Tooley racing dual spring kit: TFS pushrod set: Katech C5R timing chain: Mellings high volume oil pump: ATI Balancer: Ideal performance upgraded clutch master cylinder:Tick performance upgraded slave cylinder/throwout bearing: Mantic 9000 twin disk clutch & light weight flywheel: Tuned by Doug Ring at ECS. 475RWHP/445RWTQ.Dynapack Dyno.
 |
|
|