View Single Post
Old 08-05-2010, 12:06 PM   #18
Drives: IBM 2LT RS
Join Date: Aug 2010
Location: Louisiana
Posts: 1
Originally Posted by chozn4service View Post
With Dragom's hood, he has the Airaid and the way its set up, he gets a fresh/cold air dump from the top. The way the hood is made, air coming in from the scoop flows right to the Airaid box so the filter is getting that air from the top and he's getting the ram air from the tube at the bottom. His only issue is that the hood doesn't come with the inner liner as stock so this prevented him from getting the seal the Airaid design uses with that setup. I suggested he get some foam pipe insulation which he did and this closed off the inside of the box once the aftermarket hood is closed. He says he loveggs it!
Couldn't we just use the foam liner from the stock hood and simply cut out the hole where the fresh air comes in?
2LT-RS is offline   Reply With Quote