Looking good man... thanks for the updated pic of it in use.
As for the part #'s and stuff... I'll just say this and I'll drop it because I don't think you're picking up what I'm putting down.
You are the one that posted the GM part #'s on page 1 of this thread which included 19115655 as the part number for the connector with 6 wires coming out of it. That number is for the harness, not the actual connector. It just so happens the harness is just the connector with 6 wires coming out. Again, this is a GM part #. Delphi/Packard have a different number for that connector. Delphi/Packard does not sell the harness. I actually looked up 19115655 on the GM parts site and up came a print for that harness. It shows what the Delphi/Packard part # are for the connector and the terminals. As shown in your post of you entering that part # into Delphi's website... 15488869 actually brings up some information describing it as a 6 pin connector. If you would click on the tab to the right of what you brought up that says "Prints, documents, etc...", my guess is a pdf would pop up that has a drawing of the connector. I would also guess that the connector in the drawing would look exactly like the connector you took a picture of with the 6 wires coming out.
Perhaps, I'm the one confused in all this. If you received the 15488869 part and it wasn't the right one... then I apologize. The way I understand it though, you're telling me that that simply isn't the right connector based on the fact that 15488869 is not the same as 19115655. I think I've already explained this to death. I will post a screen shot of the gm parts print that I pulled up today, tomorrow morning, so you can see what I'm talking about.
It really has no bearing on what you've done or what will going to do so really it's a moot point. I was simply trying to find a cheaper means of getting that connector for anybody that wants to, including you, as it may bring down your production costs.
Quote:
Originally Posted by 2SSRS
You don't understanding me brother... That is not the right part Number...... It will not fit in the Switch.
But if you like try it.
Any way here are some pics it brighter then it looks in person, By the way it is siting on top of the dash.
|