OK... now I'm following. I understood what you were saying to begin with but, it just wasn't adding up until that bit of info. Guess I just needed you to qualify it with you visually confirming it wouldn't fit. In any case, I had the same thing happen with the homelink harness. I was wanting to do a plug n play solution but, JST sent me the wrong connector. It was the right amount of pins and very similar to the one I needed but, it just wasn't right.
I know it's frustrating for guys like us trying to get this stuff to work because we have to deal with GM and the other manufacturers and trying to get the right information is like trying to figure out how to split an atom. Actually, it's about as frustrating to do when you're doing the work for GM as well. Lots of hoops to jump through just to get a simple answer.
In any case, I apologize for the misunderstanding and glad it's cleared up. I'm really interested to see what it's going to take to get the HUD mounted now. If you need any help with getting prints or anything, let me know. I'll use my resources to help out as best I can.
Quote:
Originally Posted by 2SSRS
I understand all that, But what i am trying to tell you, Is i have the part number for the connector by its self and it not close to the number you have the alignment rails are not in the same place on the bottom as the connector you have the number for.
That's why i do not think it will fit into the Switch.
|