Quote:
Originally Posted by Darth Martel
OK... now I'm following. I understood what you were saying to begin with but, it just wasn't adding up until that bit of info. Guess I just needed you to qualify it with you visually confirming it wouldn't fit. In any case, I had the same thing happen with the homelink harness. I was wanting to do a plug n play solution but, JST sent me the wrong connector. It was the right amount of pins and very similar to the one I needed but, it just wasn't right.
I know it's frustrating for guys like us trying to get this stuff to work because we have to deal with GM and the other manufacturers and trying to get the right information is like trying to figure out how to split an atom. Actually, it's about as frustrating to do when you're doing the work for GM as well. Lots of hoops to jump through just to get a simple answer.
In any case, I apologize for the misunderstanding and glad it's cleared up. I'm really interested to see what it's going to take to get the HUD mounted now. If you need any help with getting prints or anything, let me know. I'll use my resources to help out as best I can.
|
Here is where its at with the install in the car, First i need to find a 2011 car and make a stencil for the cut out, Next i need the trim part,( but that will not stop the install) hope to start in a day or two at the most, But today i was ordering all the wires and plug and play connectors to make the first 50 harness, By the way if you find that GM is back ordered on the less expensive harness you will know why,
I understand that its a lot of cash for one harness But like i said some time ago The info i got was from the head of sales for Delphi and he told me that the connector and Terminals are not there's.