|
You can only use 1 sensor for the vehicle. If you want 2 sensors, for what im not exactly sure, you would run one through the vehicles pcm, and the other to an external gauge.
If your asking about 2 sensors because your assuming the vette runs 2 of them, the answer would be, we actually ditch the first sensor out of the plug itself. All we do, is use the wires that originally controlled the sensor at the MAF, and relocate them about 18" back in the loom.
It is extremely simple to convert over to the new sensor. All you do, is cut the 2 wires at the MAF plug,that go to the IAT sensor, and pull them out of the wire loom. The plug used for the GM temp sensor, is a common plug, so you can buy it at most auto parts stores. All you do, is take those 2 wires, and pin them into the new plug. Its that simple. Its about a 10 minute job.
The hard part would be finding a place on the lower manifold to tap for the new sensor.
|