[GMRULZ]

Originally Posted by SRT10KLLR

Adam from ST out here in CA ran 10's with just a KB. No headers, CAI, cam etc. just a lot of boost and that was in about +3000 DA.

Here is the thread.
http://www.camaro5.com/forums/showthread.php?t=72150

I did not see him on the 1/4 mile fastest list. I didn`t look through all the threads to see, my bad. He needs to add his time slips to the 1/4 fastest list. But running 13.5lbs on 100 octane is not too safe in my book on a stock internal motor. I`m at 7.5lbs till 5900 where it spikes up to 9.1 at 6400rpm redline. I run shell 93 gas and we are running about the same times 10.99@125 vs 10.90@125. I do have headers and a CAI but he mentions that massive 4.5 inch air intake that he used, so I would assume its similar to having a CAI. While very impressive, its not something the common guy is going to want to run, whereas as anybody could run my setup and I think that is where this guy is going w/ this thread. .

Here`s Adam`s quote#

Originally Posted by Adam@ST

Almost...
FULL weight car with a cage,stock exhaust manifolds and cats,stock eng,trans,rear diff,axles, etc.
The MODS are:
Kenne Bell 2.8 @13.5 psi(which includes a 4.5 CAI which locates the filter in the front facia)
Magnaflow Cat Back exhaust system
Drag radials
Custom tune on 100 octane
I run the car on the street @505 rwhp on pump,change the pulley,tune,and add 100 octane, and instant 10 sec street car.
Thanks Adam

To compare:
My car, full weight car, 5/8 tank of fuel, stock internal engine,trans, rear diff, axles.
The Mods Are:
Whipple 2.9 @ 9.1psi at peak
ARH 1 7/8 headers, w/ cats and magnaflow mufflers
ADM Race CAI
Tune on 93 octane
stock size nitto 555r drag radials on stock wheels
No need to change the tune and up the boost to make it a 10 second street car.

Regardless Adam`s accomplishment is awesome. I`m not downplaying it I just think the OP is looking for something he can mod and forget about.