Quote:
Originally Posted by MAZZ77X
I'm about to tackle a spring swap front and rear. I got a set of BMR springs, 1.4/1.0 and would love to read a few write up's of the job at hand just to familiarize my self.
Also the springs look very similar to each other (Front/Rear) and it's hard to tell them apart. Shouldn't the fronts look a lot beefier than the rears? No identification marks on them either.
|
Your rear springs should have the SP021 part number printed on them. The front springs should have "BMR" printed (part number should be wiped off).