View Single Post
Old 01-10-2011, 08:06 PM   #1
VIR Specialist

JusticePete's Avatar
Drives: Camaro Justice
Join Date: Jun 2007
Location: Virginia
Posts: 20,245
OE Quiet Endlinks with Spherical Function

Spherical endlinks have been a staple on race cars for years. Spherical endlinks are not perfect. They are either noisy when you bolt them on or will become noisy after you use them. The range of motion can also cause issues with your setup.

Pedders new endlinks use a unique process. Unlike a traditional cast ball and stud, Pedders endlink ball joint starts life as a ball bearing. The stud is friction welded to the ball bearing. There are NO bolts. The housing is a precision casting with an extreme high temperature epoxy coating for a virtually perfect fit.

For OE, Xa coilovers and brand-x coilovers order CAMENDLINKKIT1

For Supercar coilovers order Camaro Endlink Kit Supercar

Camaro Rear

The function is far better than thje lame picture I have on my laptop. There are better pictures available in out catalog, but I'll get a better one up when I am back in the office.

This just in from PRI

GM and Pedders? No, Pedders does not make the GM Race Endlink. Pedders and GM do use the same ball joints. Two Great Great Companies Thinking the Same Way.

Last edited by JusticePete; 09-26-2013 at 12:10 PM. Reason: Better Picture Inserted
JusticePete is offline   Reply With Quote