I had to remove the bumper cover on my father's 2011 2SS to install headlights......and after finishing the install and replacing the bumper cover, it is drastically misaligned towards the center of the hood.....near the point. The drivers side, where the hood and bumper cover meet....that is perfect. The passenger side of the hood is slightly low (1mm), but I can probably tweak it with the hood bumper over there.
The problem is the center most portion of the bumper cover, above the Bowtie in the grill. The bumper cover is a good 6mm higher than the hood. I did no altercation of any the hood height at all. The absolute only thing I did was remove the bumper cover. I am somewhat stumped as to how the bumper cover is higher than the hood. I figured if anything, it would be lower. My reasoning for that, is there were some shims that were under the bumper cover on the top radiator cross brace.
Here are a few pics to clarify. I am hoping someone has dealt with this before, and can give me a trick to fix it.
