Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com - View Single Post

edog · 02-06-2009, 09:59 PM

I thought I read at the end of December each car show in 2009 would have a production model Camaro we could sit in.

I went to the DC Auto Show today to check out which Camaro they had for display. They had the IBM and the SIM. Both of them looked AWESOME, but they were roped off and the doors were closed. They stated they were pre-pro vehicles, and the instructions were not to allow anyone to see the interior or sit in them. :(

I drove 1 hour there and two hours back through rush hour just to see the color.

I am very thankful for the opportunity to go to Philly as a guest of GM, and Scott and crew did an outstanding job with the event. If I would have known the vehicles were pre-pro and closed I would not have driven up to DC.

02-06-2009, 09:59 PM	#1
edog Drives: 2010 2SS/RS IOM Join Date: Oct 2008 Location: F'BURG VA Posts: 3,832 View My Garage	Disappointed with the DC Auto Show. I thought I read at the end of December each car show in 2009 would have a production model Camaro we could sit in. I went to the DC Auto Show today to check out which Camaro they had for display. They had the IBM and the SIM. Both of them looked AWESOME, but they were roped off and the doors were closed. They stated they were pre-pro vehicles, and the instructions were not to allow anyone to see the interior or sit in them. :( I drove 1 hour there and two hours back through rush hour just to see the color. I am very thankful for the opportunity to go to Philly as a guest of GM, and Scott and crew did an outstanding job with the event. If I would have known the vehicles were pre-pro and closed I would not have driven up to DC. __________________ Update...Build in process, Forged Rods, Pistons and rings, Johnson Lifters, NOVI1500 ECS SC, 13lb boost or more, LS3 Conversion 114/228/241 COMP CAM, Frostbite 4 row Aluminum radiator, 6L80 built, Circle D 6L80 PRO SERIES MULTI 258MM 2D, Stock 3.45 gears, 1-7/8 American Racing Headers w/HF cat, X-Pipe, Lingenfelter dual fuel pump, E-85 flex sensor, ATI super damper pulley, Ported TB, 160 therm, Trans cooler, Pedder's sways/end links/sub frame bushings, BMR trailing arms & toe rods, Coil overs. HP/TQ pending Last edited by edog; 02-07-2009 at 04:29 PM. Reason: I mis understood information from Scott. I was corrected.