Quote:
Originally Posted by cdn2usa
I used paint remover (tuff-strip) purchased at Lowes. Had it around for years after doing some furniture re-finishing. For the doors it worked great, first taped it off, applied with a small modeling brush, wairted less than a minute removed with a Q- tip. After about four applications it was perfect. If you leave it on for too long it would eat the plastic. For the dash I have only done the driver's side so far. I took the paint with no problems but the look is better when it's sanded IMO, used 600 grit.
|
Where did your line start? Did it begin at the edge of the bevel? Once you got it sanded down, did the light shine through nicely? Thanks for your response.