Ok so found this on a site and let em know what you guys think?]
Quote:
as for the rattling, it's an easy fix..
have to take them off, there are some allen bolts on the motor side, remove them and open the motor up.
inside the plate is mounted to the arm and there are some allen set screws holding it in place, remove them, clean and use some super high heat loctite (get threadlocker 2620 it's rated at 700 degrees) tighten it all up..
|
Is it possible to take it apart beside the part thats welded on?
Cause I really wanna try this and just want some opinions first!
Thanks