Okay, all the wiring is going to be made outside of your EE's. Hook up you relay to your ballast and the side with the fuse to your factory harness. Once your done, remove the halogen bulbs from your EE's. You are not going to mess with any of the wiring inside the EE's. Once you remove your halogen bulb, cut a hole on the rubber part of the seal for your eagle eyes where that blue/white/black plug comes out that connects to your factory harness if you were to still be using the halogens. Pull your ends of the HID bulbs through the rubber and insert the HID bulb in. Once in, seal the rubber part and connect the HID plugs to your ballast. There should be one more cable that needs to be plugged in. This cable is the control for your high beams. It will plug into that connector I was talking about from you EE's with the blue/white/black that connects to your factory harness. Read post #56 as it shows how you plug it in
http://www.camaro5.com/forums/showth...=100103&page=3
Make sure your groundings are and your done. Hope it works out for your.