[UA488Fitter]

The problems that DIY'ers have with working on AC systems has mainly to do
with the refrigerants and the CFC's that they contain. CFC's are ozone killers;
because of this are restricted substances; you need a certification to handle them.

So if you want to replace the parts in your garage your will first need to have
someone that is "certified" to handle refrigerants to evacuate them from your
AC system. After that it would be a good idea to have them purge your system
with nitrogen. You need to prevent air from entering the system; O2 and water
are real killers to an AC systems. After you've replaced the parts you will once
again need someone that is "certified" to handle refrigerants to recharge your system.

Your compressor leak is more than likely cooked seals, #18 in the diagram below.
That is a fairly easy fix; but you MUST keep everything clean and dry, you don't
want any contaminants entering your AC system. Also remember that the compressor
is 12 years old; you may want to consider replacing it.

Condenser???? Are you sure that's what they mean? #3 or #4 in the diagram?
The condenser sits in front of the rad; unless it has been punctuered by something
it should be just fine. I would think that your shop is refering to #4 the receiver.
This part is commonly call the accumulator in the refrigeration industry. It is there
to dry, filter and receive/accumulate (hold) the liquid refrigerant prior to being applied
to the evaporator. As this part contains desiccants to remove any moisture, it is
commonly replaced any time the AC system is opened up.

Parts? Summit Racing, NAPA, or similar outlet; but here's a word of caution.
Make sure that the parts that you purchase are NOT "made in China"; parts coming
from China are GARBAGE, I repeat GARBAGE, of LOW quality, inferior and will not last.
Pay the extra dollar and find parts made in the USA, Canada or Europe; parts
made in these places will be of much higher quality and will last a long time.

So if after reading this long winded advice, you still feel up to the task; fly at it.
Though you should keep in mind that if you get the work done at a reputable shop;
their work should come with a warranty. Plus you will be helping your local economy.