|
Painting uethane GFX Kits
I bought the Street Scene kit from Stillen a while back and was just able to get it into the shop for paint/install. The issue was pin holes that appeared after the 1st sealer coat was applied. This resulted in the painter to have to fill and sand the pieces multiple time to get it a smooth finish. The finished product now looks amazing, but at a huge labor cost to me. Is this most likely the result of a poor molding of the material or something else. Not sure if the type of sealer he used could cause this, but he's pretty good and has done body kits numerous times and has never seen one this bad. Any ideas?
Thanks
|