[flht99b]

I painted my calipers with G2 epoxy black paint and after they dried installed silver Chevrolet and red Brembo stickers in the exact location, size and font that the OEM lettering had. I removed my rotors and brake pads and left the calipers in their original mounting location to paint. I taped off the ends of the bolts that hold the caliper halves together as well as the bleeder screws and metal line between the caliper halves for added OEM look detail. While the rotors were off I painted them silver with Ceramic spray paint. If you take your time and clean everything well, a brushed G2 finish can rival a powder coat finish in quality. I did not sand off the factory painted Chevrolet and Brembo lettering, it disappears quickly under the G2 paint. When using the G2 with a brush, get a soft natural hair 1" to 1.5" brush instead of using the throw away nylon brush G2 supplies, the brush strokes will be finer and disappear as the G2 paint cures. I used approximately 2/3 of the container of the G2 paint to coat all 4 calipers 4 times but since all of paint was catalyzed, it gets thrown out. So far after over a month and some severe heat cycles the paint and high temp vinyl stickers look new. And no, I did not clear coat over the vinyl stickers.
Ed M.