Hi guys and thanks in advance for any help I just did a complete Dod and vvt delete and installed my new cam and the whole delete kit so
Question 1: On the original L99 valley cover there is a sensor in the rear that has no where to connect with the new ls3 valley cover? what do you do with the connector?
and #2 there is a two wire connector that was going to the dod on the front cam cover, this too has no where to connect and I am getting a cam sensor code after it ran fine for a couple minutes while beginning the tune then started to run bad and stall with the P0010 code for the cam sensor continuesly coming up?
I am a new member and will fill out my info latter today.
Thanx..