Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com - View Single Post

Swytch · 07-01-2011, 08:24 PM

I was more curious about the RS specific stuff i think. The stuff behind the O-ring sealed plug:

Does all that electronics need to come out before its baked?? I cant seem to find anything about it on the other DIY's..

Edit: After the photo was taken i did take the HID bulb itself out, but there are still some wires and a small circuit board you can just see in the lower right hand side.. should those be safe during the baking process?

07-01-2011, 08:24 PM	#3
Swytch Drives: 10 2SS/RS Black, 99 Daktota Join Date: Apr 2010 Location: Maine Posts: 256	I was more curious about the RS specific stuff i think. The stuff behind the O-ring sealed plug: Does all that electronics need to come out before its baked?? I cant seem to find anything about it on the other DIY's.. Edit: After the photo was taken i did take the HID bulb itself out, but there are still some wires and a small circuit board you can just see in the lower right hand side.. should those be safe during the baking process? __________________ Kooks Signature Series Headers 1-3/4 stepped to 1 7/8, Kooks 3" High Flow Cats, Vararam OTR Cold Air Intake, JRE Performance Tune, RX Catch Can, RX Oil Breather, LSR Tri-Ax short throw shifter, AAC Red/White Halos and Fog Rings, AAC Knight Rider Scanner Bar Last edited by Swytch; 07-01-2011 at 09:13 PM.