View Single Post
Old 07-28-2011, 02:58 PM   #4
Epic; Winning!
PIANOMN's Avatar
Drives: 2010 1SS ABM
Join Date: Feb 2011
Location: Las Cruces NM
Posts: 595
Originally Posted by Jchaluja View Post
check out Texas Speed or Jannetty racing...there are many others (can't remember)'ll need internal forged rotating assembly, good set of heads with valve springs....dual fuel pump and you're good to go...if you are doing the build, it is probably $2k-$3k for the internals + $1k for the pump....if not doing the build....about $6k-$7k not including labor to install the you'll need a bada$$'ll need axels and clutch as well; another couple of grand as well....

you can run low boost (5 psi) and it should be fine for a long time....stock!
personally, I'm not planning on a superbuild, just going to stay around 5 psi (until I hit the lottery!)
Lots of parts from SouthwestSpeed... Thanks Ivan!!
PIANOMN is offline   Reply With Quote