Quote:
Originally Posted by Chris_B
Since this project is a bit more complicated than just a bezel change, we are jumping over a few technical hurdles with our development partners. We expect to have a much better idea on ETA in about two weeks, if all goes as currently planned. There several elements to this solution (injection mold tooling, electronics, programming, etc.), which is why we have chosen to work with the best of the best instead of taking short cuts. Of course, that means we are not in full control of the development timeline either. Thanks to all for the continued patience!
|
Got it, two weeks. I can wait that long. If you need some DIY testers for these once they are out I would like to volunteer Kaylee.