Quote:
Originally Posted by CamaroSpike23
You guys do realize that this is the 4th gen section and that he's asking about LT's for an LS1 right?
to the OP, Check out Hooker Super Comp LT's. they have a slip-fit joint on the #1 primary that eliminates the need to have to disconnect the steering rod to slip it between the primary tubes.
Also, if you are planning on installing LT's, get a new set of polyurethane engine mounts and change those out while the exhaust is off the car. it will help realign the engine in the engine bay and raise it a hair or two which will allow for easier installation of the new headers.  |
You do realize that ARH hand Kooks makes LT's for the LS1 4th gen right?
Also you don't need to remove the steering shaft to install the ARH headers on these cars.
I don't know that any headers for these cars has the steering shaft running through the headers to begin with.
__________________
2011 Camaro SS, White/Orange, LSR Short Throw, CAI
1998 Trans Am, Red, H/C/I, 3200 CircleD Stall, full suspension
2004 GSXR 1k, Matt Mladin Edition