Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com - View Single Post

BloodUSMC · 11-13-2011, 02:12 AM

Today I spent almost 8 hours installing my OBX Long tube headers.

here is my current concerns.

One side of the headers (passenger) I couldnt get 2 bolts back in. I think its the gasket out of place or maybe something else. But if it was the gasket how the did the other 5 bolts go in?

I also couldnt put any of the heat shields back. is that a problem?

I test drove it and my car sound like its cammed lol. Drove about 15 miles and no check engine light. No tune yet.

It is way too loud.

Personally I like my MRT V1 sound by itself. This just sounds way too loud and its not deep like before I installed it.

BTW. I left the stock resonators on.

11-13-2011, 02:12 AM	#1
BloodUSMC Blood Sucking War Machine Drives: Black 2011 Camaro 2LT/RS - A6 Join Date: Feb 2011 Location: Northern, NJ Posts: 661	OBX LT headers install Today I spent almost 8 hours installing my OBX Long tube headers. here is my current concerns. One side of the headers (passenger) I couldnt get 2 bolts back in. I think its the gasket out of place or maybe something else. But if it was the gasket how the did the other 5 bolts go in? I also couldnt put any of the heat shields back. is that a problem? I test drove it and my car sound like its cammed lol. Drove about 15 miles and no check engine light. No tune yet. It is way too loud. Personally I like my MRT V1 sound by itself. This just sounds way too loud and its not deep like before I installed it. BTW. I left the stock resonators on. __________________ BLACK 2011 2LT/RS COUPE. Roto Fab Intake, MRT 1.0, OBX LT Headers, Magnaflow resonated x pipe, Trifecta Tune