View Single Post
Old 11-29-2011, 11:23 AM   #9
RickRay's Avatar
Drives: 2010 CGM 2LT/RS AUTO
Join Date: Jan 2009
Location: Montreal (South Shore)Quebec, Canada
Posts: 6,494
Originally Posted by RickRay View Post
Hope you glued it from the Inside only...

And Yes you did a great job...Looking real good...
Originally Posted by Hellfighter View Post
what do u mean.

Also what dremmel tool did u use , aside from that, and what did u cut on the inside? does it fit ok when placing bumpers back?
The proper way to Glue this together is you put the glue/epoxy on the insert(inner) only & not on the front(outer).

That is correct, there should not be any adhesive on the outside. Adhesive is used to bond the inner ring to the inner surface of the port and NOT the bumper.

This image has been resized. Click this bar to view the full image. The original image is sized 1045x596.
Member of 'Club Elite' #70
2LT/RS Auto / Solo HFC / Solo Mach X-LLT J-Pipe / JBA Headers Shorty
CAI - Cold Air Inductions / VMAX TB / Trifecta Tune
Hotchkis Max Strut Brace / Blade Dovetail Spoiler / Elite Catch Can
ACS T3 Hood Ports / T2 Bumper Ports / T2 Splitter / ACS T1 Led Light Kit
ACS Rockers / ACS Composite Hood Liner / ACS Upper Rear Quarter Ports
ACS Front Wheel Mud Flaps / ACS Rear Wheel Mud Flaps / Vitesse Throttle Controller
Pedders Drop Suspension / BMR Lower Control Arms / Style 41 ZL1 Wheels /
Oracle Afterburners / Oracle Concept SMD Side markers
Complete SS Brembo Brakes Set

Last edited by RickRay; 11-29-2011 at 11:34 AM.
RickRay is offline   Reply With Quote