View Single Post
Old 12-06-2011, 03:39 PM   #1
Drives: 2016 1LT RS Camaro; 72 Chevelle
Join Date: Apr 2008
Location: Central Point, OR
Posts: 5,534
Send a message via AIM to Jason@JacFab Send a message via MSN to Jason@JacFab
No drill / No adhesive front license plate mount brackets from JacFab!

Available from JacFab, a front license plate mount bracket that doesn't require drilling into your new sweet ride's bumper, and leaves no adhesive residue to clean up!

These are CNC waterjet cut from 3/16" thick 5052 aluminum. From there they are bent, on a CNC press brake, and then powder coated semi-gloss black. They bolt onto the bottom of the bumper with two existing bolts, and are supplied with all new stainless hardware.

Some states require than you have a front license plate, some don't (lucky you!), don't give the fuzz a reason to pull you over! The bracket comes off easily for car shows, and doesn't leave any unsightly holes in your painted front bumper.

They are available in 2 different styles. Bent style, of flat.

Bent Style

Flat Style

Both styles are available now for v6, and v8 cars! Feel free to check out the JacFab Website, you can order directly from the Camaro Products page.

Below is a video shot with a GoPro camera that was taken while prototyping the bent style v6 bracket. I took this video to see how stable the bracket is at driving speeds, and as you can see it's rock solid.

Last edited by Jason@JacFab; 02-21-2015 at 11:59 PM.
Jason@JacFab is offline