[Tigg]

Originally Posted by Big Top Gt

That's a pretty good idea.

You couldn't convince me to put a spoiler on my car that was ONLY held on by 3M tape, but in that center area, that might be a great solution.

As an aside, I also own a 98 Cobra with a Saleen S281 Spoiler on it. The early designs came with a 4 bolt setup that used the stock locations. The later designs, which I have, removed two studs and replaced it with 3M tape.

When I get some extra cash I am going to pick one up, fit it to the car then send it off for paint.. the only reason I would even put the tape there is to control the wind that may get under it..if you look close at the pictures of it looks like it either has tape or protective foam around where the studs are anyway..if it is tape , no need to do anything else ..if it is foam, replace it with tape.. This is all just speculation I won't be sure till I get one and attempt to make it fit. The only other thing I would see as an issue is where the center holes in the trunk lid are as in relation to the brake light.. if they are hidden under it I say rout out the underside of the spoiler so that you can use one of them to route the tail light wires through. Get nice water proof grommet and a plug for the other side and you are set.. Again I am only going by the pictures but when I get one I would much rather make it fit the car than the car fit it..