Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com - View Single Post

CiscoBee · 02-14-2012, 12:26 AM

Had my VDI doors since May 2010. Installed with the help of my son in about 8 hours.

Once the front fascia was loosen the fenders came off

The cutting of the inner lip of the fender is simple with the right tools, a steady hand and some painters tape

The factory hinge comes off and the VDI hinge is bolted on without removing the doors.

Passenger side kit installed

There are 2 allen head set screws for adjustments

Used as a daily driver with over 59000 miles on Bumblebe Camaro the doors are great. They open about half the distance of a stock door and only lift up the doors at the car shows, otherwise no on would suspect them on the car.

02-14-2012, 12:26 AM	#29
CiscoBee Account Suspended Drives: 2010 Camaro Rally Yellow 2LT Join Date: Aug 2009 Location: Smithtown, NY Posts: 689 View My Garage	Had my VDI doors since May 2010. Installed with the help of my son in about 8 hours. Once the front fascia was loosen the fenders came off The cutting of the inner lip of the fender is simple with the right tools, a steady hand and some painters tape The factory hinge comes off and the VDI hinge is bolted on without removing the doors. Passenger side kit installed There are 2 allen head set screws for adjustments Used as a daily driver with over 59000 miles on Bumblebe Camaro the doors are great. They open about half the distance of a stock door and only lift up the doors at the car shows, otherwise no on would suspect them on the car.