I will try to address everyone here and if I miss someones Questions I apologize.
I have not seen the MACE dyno, but if it is close that is good. The nice thing as that with the different material, being one piece and just 9mm it should be an easier install, not need new bolts and work with the Vararam.
I did not drive it yet as the roads here are a bit sloppy. I am sure Joe will give his 2 cents once he gets it back.
I will have my first runs here tomorrow, but no plans for a ported intake on my end. I am sure it will help, but I have yet to see any results from those currently available that have proven results, not just theory.
Runs were done in 3rd gear. I tried to get a couple 4th gear runs, but they were quite choppy and actually a bunch lower dyno number wise.
I do not see why the engine cover will not fit, but will find out tomorrow.
Thanks Joe, I will call you tomorrow.
I have one here with your name on it TJ91
I updated my set of instructions that I made today with more pics and info. It may be a final, but need to go through it some more. To get the instructions you will need to get them from me online as it will be too much to print out each time. I attempted to post it here but it would not go. I can email them to folks again.
Thanks and let me know if there are more questions.
Mike Norris