Quote:
Originally Posted by ChadG
Bmore you should really start a thread about how you got the 25mm + Vararam to work out with tons of pics! 
Not like you're busy with Vince or anything!  |
Uhhhh.. you are no good chad LOL!
Got everything I need for the dyno, FINALLY, so I should be back on the dyno sometime early next week for my own tuning needs and also to find out if the update is going to happen or not.
As far as the vararam and 25mm spacer...I just don't know if is really even a thread starting subject. You basically have to do a little sculpting and just cut the rear neck to an angle until you are comfortable with the gap at the radiator. I actually used a die grinder with my 80 grit cartridge rolls that I use for porting since I had it next to me at the time of doing this. A dremel would work perfect too. Also note that the angle does not have to perfectly match up with the tip of the throttle body. The rear neck will line up straight with the top and bottom area regardless of the angle due to the red coupler that hold the rear neck and the throttle body together. You just have to focus on the front gap. Just shave off small amount at a time until you are comfortable with the gap.
I was going to take some pics for you guys today but I ended up making a mistake and spilled some engine degreaser on my maf and all over my vararam tray and filter
. I spent most of the day today cleaning up the mess.
I will post up more pics for you guys sometime tomorrow
