View Single Post
Old 04-26-2012, 10:49 AM   #10
[COTW 5/12/14]
vroomapunk's Avatar
Drives: 2012 CRT NF Cammed 2SS/RS
Join Date: Oct 2011
Location: NOLA
Posts: 6,109
Originally Posted by Wuiquen View Post
cool.. I will look into the primer.. so you recommend to use adhesion promoter then gray primer then paint and then clear, right??

what did you scuff and sand with?? will the primer fill up any scratches???
Sorry if all this questions are stupid but i dont know much about painting
I use a fine grit sandpaper, or a scotchbrite pad, scuff pad, etc. If the sandpaper you have is too rough then just rub it against itself until its not so harsh.

I say yes to the adhesion promoter, then gray primer, paint, then clear. But be sure to clean the surface with alcohol, and try testing that combination on a piece of plastic, because sometimes using different brands can make the different stages react differently.
vroomapunk is offline   Reply With Quote