[camarograna2]

Hmm i have some different answers for you

Originally Posted by Leah's 2SS

Best place to mount microphone?

Under the rear view mirror mount

Originally Posted by Leah's 2SS

Best place to mount antenna?

Where center speaker was

Originally Posted by Leah's 2SS

Can USB's be mounted in center console or where is the best place?

If you have IPOD/iphone and you want to play from it you need the cable KCA-iP202. It does reach the center console hole where the factory connection was at but stretched. So i have mine in the glove compartment. I did however utilize a usb to mini cable as my 2nd usb cable to connect to the factory USB connection. That's the one i use for firmware updates or to add pictures

Originally Posted by Leah's 2SS

Tape over speaker inside Scosche if blinkers/sound is too loud (?)

Doesnt sound bad at all in my opinion. The speaker is in the back of the dash kit behind the touch screen.

Originally Posted by Leah's 2SS

Installing Kenwood backup camera: Can it be mounted without drilling?

The one I have (Third Eye TE-SBC) was mounted with some type of adhesive instead of drilling. However the mount has the whole to drill.

Originally Posted by Leah's 2SS

Backup sensors and steering wheel controls working

Backup sensors do work.
SWC For the 9990 you will have to mod the wires. Here is the link to the PDF i received from Scosche. http://www.camaro5.com/forums/attach...0&d=1337862200

Originally Posted by Leah's 2SS

Also, what is a decent price for Dynamat, including installation in doors and rear deck?

I did mine in 2 phases.
1st phase I did the trunk only. I used 1 pack of Ballistic SSBK at 250 for material and 250 for labor
2nd phase I did the entire rear of the inside of the car including the rear side panels & top of the rear deck. I also did the doors (on the door panel and on the door). Used 2 packs of Roadkill RKX36B at $350 and one pack of Roadkill RKO12 ( this is foam pad) for $75. Labor for the 2nd phase was 550