[nikos30]

I figured that I'd make my own thread, with my own questions because I keep asking questions on other's threads.

So I have the Ported intake manifold, the plenum spacer, and the 25mm insulator and I have already installed the PIM and the insulator. I am now installing the plenum spacer.
My plenum spacer did not come with the 4 bolts that hold down the manifold. I have the new ones that came with the insulator when I bought that. I am worried that those bolts will not fit. I am not installing anything until I am sure, because I am leaving tomorrow afternoon...

Also, the bolts that came with the insulator (only 4 of them, the ones that hold down the manifold) aren't all the same length. Only one of them is shorter than the others. When I installed the insulator, I just ignored that it was shorter and I used it as one of the four. It worked, but if its wrong, or if mace was supposed to send me another bolt, ill go buy it. idc, whatever makes everything work properly without cutting corners in the end.

Thanks for the incoming help (please be some)