Quote:
Originally Posted by JANNETTYRACING
Nice, You may need to modify your bracket so that you will have room to move the sliding Idler pulley toward the tensioner to take up more belt slack and load the tensioner more.
What you have to avoid is the tensioner maxing out and going against the stop under load very hard to check unless your on the dyno.
Ted.
|
I still have room to move the stationary pulley over about 3/4 inch. And I can get a smaller belt. The one I got was the
K060950. Once it stretches I'll need to move the stationary or get a new belt. Sure wish you guys were closer. lol
Quote:
Originally Posted by CamaroSpike23
Gopro with a light under the hood. Just make sure everything is fastened down securely.  |
Meh........ I'll have Bonnie sit up there.
