View Single Post
Old 10-17-2012, 09:06 PM   #775
pyr0b0y's Avatar
Drives: The Neighbor Hater
Join Date: Dec 2010
Location: San Mateo, CA
Posts: 4,090
Originally Posted by Nathan Moreno View Post
[QUOTE Should have some dyno numbers for everyone tomorrow! So stay tuned!!!
I get these little guys on my thread a lot so........... I figure this is a spot where I can give some of them back

Josh good luck with the tuning. Can't wait to hear your results![/QUOTE]

Originally Posted by Dtrimpi87 View Post
Awesome brotha, cant wait to see the numbers.
Thanks for the popcorn, although i was too nervous to eat while seeing the car on the dyno!

believe it or not, ran into another issue that needs to get hammered out before i reach max power. My car is losing 20-30psi fuel pressure after 5k rpms. It could be as simple as a clogged fuel filter, but I'll also have to check voltage to the fuel pump. Someone suggested running the power directly from the alternator, so I might try that. Aeromotive says it supports up to 1300hp on FI application, and it was falling on its face at 600whp....very disappointing...

The rev limiter is set to 5k rpms so i can track it this weekend, it makes 670whp/780tq @ 4k rpms.

Tonight, I'm taking the rotors off to be turned for this weekend, and swapping out the pads for my aggressive track ones. Also getting another set of R888s installed on the rear 19" rims. Got a lot to do before the CA fest this weekend in Bakersfield. Looks like I'm leaving San Jose around 3am, trailering the car all the way to Bakersfield, and the girlfriend is driving her camaro too. Let's just hope everything falls into place and its turns out to be a great weekend....oh and own some more GTRs and Vipers on the track!


Mast Motorsports Built LS3 Stroker 418, IPS GT35R Twin Turbos, Exedy GTO4XD Twin Disc Clutch, Aeromotive A1000 Eliminator Stealth Fuel Pump, AEM Meth Injection, DSS 1400hp Axels, BC Coilovers, Pfadt & BMR Suspension, Hawk HPS Pads, Drilled/Slotted Rotors, Hurst Shifter, Custom Roll Cage by Blu808, T3 Ports, 22" Custom Concave Mesh Rims
pyr0b0y is offline   Reply With Quote