View Single Post
Old 02-24-2013, 09:48 PM   #16

OzzySS's Avatar
Drives: 2013 2SS/1LE, 2004 Cavalier
Join Date: Sep 2012
Location: jax, FL
Posts: 1,337
next up was my CAI...i went with the roto-fab, mostly because they're one of the big reputable brands i read about here, and i could color-match the box. also, there was a great price on it when i bought, saved around $50 from the other brands.

nice and clean after about 400 miles

for the most part, the instructions were good, and easy enough to follow. the stock intake was easy to remove in just a few minutes.
for lack of any instruction regarding the ground post, i just left it where it was...i did have to cut a plastic retainer or two...

...and then just work the cable around the outside of the new was a tight stretch, but it worked. i might relocate it sometime in the future, but for now i'm not worried about it...

the separator that comes with the 1LE left me with another deviation from the, i just connected it up as best i could and laughed to myself...

it's a little wobbly, but it works and i doubt it'll disconnect...
Build thread linked in the pic...

OzzySS is offline   Reply With Quote