Quote:
Originally Posted by Q's 91z28
The job is a pain in the a$$. If i remember correctly, you'll need to remove the rivits that hold it in place. Be careful when you seperate the motor from the arms because the coil will uncoil and can cut you pretty bad. We used some straps to keep it from uncoiling. Good luck and don't get frustrated.
|
Thanks for the information on the dificulty of this task.
You are right about the rivits. I started drilling them out, but did not get either one finished the first night I worked on it. After reading your post I decided to check around to see how much it would cost me to have the motor installed by a shop rather than taking on the job my self. It was going to run me an extra $160. Some was the fact that the shop who would do the work would only use their own motor and it costs more than the Autozone one I had, but most was the 1-1/2 hours of labor. I decided to pay the extra $160.
Thanks,
Mike
