[05SilverStreak]

Ok....little bit disappointed. Was going to try the 50 shot today and maybe.....I said maybe, work up to the 100. Went back to stock tune and finished installing the electronics in the kit. Was ready to go. Oh, and 1 step colder plugs were put in, and higher.....much higher....octane fuel and even a fuel booster a buddy recommended. so a half a tank of great fuel and colder plugs. Turned everything on and the ****in solenoid wont hold the bottle pressure. I dont know if its bad, (cause I did remember dropping it once), or if I need to better seal the hoses. All I heard was PSHHHHHH, when I barely opened the bottle. Mostly at the solenoid and some coming out the jet in the intake. (and yes I did take the air filter off), as I have the jet in the top to spray directly on the MAF. Oh well, try again later. Ive got some work to do. Do you think the solenoid is bad? or just need better sealing. Going to check wiring again, they said solenoid needs proper power source and good ground to hold pressure correctly. I hope my bottle pressure isnt too high, I have no bottle gauge yet, but they only put in 8 pounds instead of 10 for first fill so I think its ok.