Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com - View Single Post

RxDoc08 · 05-05-2013, 06:56 AM

I ended up with the same problem as you and not being able to get a small wrench to fit. I went to a local harbor freight store and bought the cheapest set of offset metric wrenches I could find and they worked great. They were long enough to be able to turn from the side of the transmission instead of having to try and get my hand near the top, and I was able to get the job done in a matter of minutes. While the wrenches weren't pretty, they got the job done. Just be careful if you go this route and inspect the wrenches before purchase. Some packages had wrenches missing teeth or out of round. Here's a link to the ones I bought. http://www.harborfreight.com/8-piece...set-32042.html

05-05-2013, 06:56 AM	#2
RxDoc08 Jason Drives: 2011 2SS/RS M6 Join Date: Apr 2011 Location: Richmond, Va Posts: 341	I ended up with the same problem as you and not being able to get a small wrench to fit. I went to a local harbor freight store and bought the cheapest set of offset metric wrenches I could find and they worked great. They were long enough to be able to turn from the side of the transmission instead of having to try and get my hand near the top, and I was able to get the job done in a matter of minutes. While the wrenches weren't pretty, they got the job done. Just be careful if you go this route and inspect the wrenches before purchase. Some packages had wrenches missing teeth or out of round. Here's a link to the ones I bought. http://www.harborfreight.com/8-piece...set-32042.html __________________ Kook's headers w/ high flow cats, Borla S-Type, VMAX ported throttle body, CAI Inc. intake, Jannetty race scoop, Roto-Fab washer bottle relocation, Jannetty rough idle blower cam, DSS 9" w/ 3.70 gears, RPM Level 6 trans, Street Slayer Twin Carbon clutch, MGW Shifter, Pfadt trailing arms.