Quote:
Originally Posted by bky
So I noticed this the other day and starting to wonder what I can do to fix it. I didn't notice the issues until after I got my tint job done the other day, however I don't know why they would have had to remove this to apply it since its not like I got the windshield done. There's a little plastic snap to put it back in place, but it pops back out after a few minutes.
Any idea how I could get this fixed? I've never bought a new car before so I was wondering-if I took this back to the dealer to have it looked at, would I be laughed off the lot?
 |
THERE IS A LONG BLACK CLIP THAT MUST BE REATTACHED TO YOUR A-PILLER IT PROBABLY IS STILL PUSHED IN. LOOK AT THE TOP OF THE PILLER BEHIND THE PLASTIC COVER. THERE IS A LONG BLAACK CLIP,PULL IT FROM THE TOP AND IT WILL POP DOWN AND PART OF IT WILL STAY ATTACHED. SLID THE CLIP OVER THE SLOT ON THE INSIDE OF THE PLASTIC COVER AND PUSH IT DOWN WARD TOWARDS THE DASH UNTIL IT CLICKS IN. BELOW IT IS A GUIDE PIN PROTRUDING FROM THE INSIDE OF THE PLASTIC COVER THAT MUST LINE UP WITH A HOLE ON THE WIND SHIELD POST.WHEN IT SLIDES INTO THE WHOLE IT WILL ALL POP IN WITH A LITTLE TAP. YOU MAY HAVE TO SLIDE THE COVER DOWN A BIT TO LINE UP THE GUIDE PIN...GOOD LUCK