Thread: V8 bolt on help desk! Now available!!
View Single Post
Old 05-28-2013, 10:58 PM   #323
Mchlgrrsn
Stroked and blown
 
Mchlgrrsn's Avatar
 
Drives: 2010 LS3 2SS
Join Date: Dec 2012
Location: Bridgewater, NJ
Posts: 1,458
Quote:
Originally Posted by Nightmare2012 View Post
So I need to vent alil from this stressful hobby. I went from a bad ground to possible blown head gasket or 3 fried piston rings! What is the possible cost of this job from anybody's experiences with this? If its too costly I might just go 422ci short block from tsp.
I'm sorry for you bro. Yes it is 427 time. Sell your block. I truly hope everything works out for you. If its the piston rings that's an engine tear down
__________________
LME 416 LS3 shortblock/Callies Compstar 4340 4"crank/Callies 6.125 H beams rods/Wiesco 4.07 forged pistons/Cam Motion custom LS1/LME ported heads /maggie TVS2300/I West 8rib 10%OD /3.2 pulley/OD cog drive/JRE tensioner/ID850 /ADM dual fuel/Kooks LT 1 7/8/magna flow2.5 /cat delete/Roto Fab CAI /MGW short throw /SPEC super twin clutch/G Force built trans,carbon syncro rear shaft upgrade /DSS 9"single CF DS /Strange 3.70/31 spline trutrac/MT DR's/earls oil cooler /tuned KHC
Mchlgrrsn is offline   Reply With Quote