Quote:
Originally Posted by whemming
No unfortunately. But here is what I did:
1. Drill all the holes in the splitter (there are indention where the holes should be)
2. Then sand and paint the splitter (I just used plasti-dip)
3. Follow the SLP splitter instructions  |
Cool!! yeah, I plan to use Plasti-Dip too. Just trying to figure out a way/place to spray it. Last couple of pieces I've done have been small so I could just put them in a box and spray em. I could lay out plastic but the dip sticks to the plastic.
I'm kind of a noob when it comes to painting parts if you couldn't tell.
