[Bell040]

Originally Posted by rray

You are free to use the attachment template, to make and sell them as desired. I don't have time to do it, working 6 and 7 full days a week.


By the way, it only takes 30 minutes to cut out 4 of the blankout plates, and fold them. The dremel and a 3" reinforced cutoff disk can cut 4 tail light housings in 30 minutes also.

yes... if you are optimistic, and you get it right the first time.

When I do stuff like this, it takes me 5 times as long because I accidentally break one of the tabs during bending... or cut too far... or cut myself

It would take me at least half of a day to make 1 set those inserts, and I would be frustrated to top it off. I would rather do this for the half day.... ...... and cut the insert slots for in 10 minutes.

Heck now that I think about it... I would probably pay $30-40 for them.

If anyone else is on board.... I will make a die, and punch a couple hundred of these out........ Now that I have consent from the designer.


.... or if someone else does it, add me to the list of people interested.