Quote:
Originally Posted by Ject
Hopefully I can help a little here.. Granted I'm not sure what the setup is for a centri but I would have to assume it has the same as any top mounted blower. The real question is do you need a 1 inlet or 2 inlet catch can... I've seen it done with both methods. Also some run 2 catch cans especially the elite engineering cans as they only allow 1inlet/1outlet instead of 2 inlets... Yes.. very confusing I know.
As you have stated, the 2 connections on the passenger side just behind the Throttle body are your typical LS3 connection points. The lower (silver) nipple goes to the Inlet of a Catch can... The Upper nipple (black) goes to the outlet of a catch can. (see my image below)
With FI... all steps are the same, except for the PCV inlet connection installation. Inlet is located on supercharger body unit somewhere.... and is routed to the outlet side of the catch can. So.. the Superchargers inlet comes from the catch can outlet... |
That is a really good photo. Not easy to get that shot.