Thread: Brake ducts
View Single Post
Old 11-04-2013, 04:08 PM   #89
JDP Motorsports

JDP Motorsports's Avatar
Drives: 2011 Camaro SS/ 2016 Camaro SS
Join Date: Jun 2009
Location: Sandy, Utah
Posts: 3,447
Originally Posted by Synner View Post
Anybody have info on how they routed their 3" tubing to fit?
Halfway there:
Looking great!!!

Originally Posted by td195f View Post
Take a look at the photos below. I used the Quantum Backing Plates and 3" hose. I routed over the top of the tie rod/rack and pinion unit and over the top of the front suspension mount on the frame then down into the air inlets installed behind the lower grill. There is a splash guard between the suspension mounts that you'll have to remove one of the plastic fasteners on to route the hose between the frame and the splash guard. This routing results in no rubbing on a 1LE. I have done two track days at Watkins Glen with this setup with no issues.
That is nicely done! I have pictures of mine somewhere but I routed them similar to your set up. I'm working on adapters to the ZL1 ducts.

Kind regards,

Jordan Priestley

Click HERE to send me a PM | | | 801-545-4215
JDP Motorsports is offline   Reply With Quote