Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com - View Single Post

OVERPAR73 · 11-19-2013, 07:36 PM

Iv'e got my front end ready to remove the bumber so I can remove the lower splitter and send it to Fastlane (H2O Printers) to be hydro-dipped. Also removed my lower side skirts to be hydro=dipped. Fastlane is currently doing my rear lower valance right now and should be done late next week. I will of course take some pics when it arrives. I'm going to do some of my interior parts myself. I ordered the carbon fiber (mydipkit) and it looks really good on some test pieces I did. I also ordered some LED lights to install on the inside of my door handles to come on with the dome lights, I'll take pics of that also.

Bill

11-19-2013, 07:36 PM	#6464
OVERPAR73 2018 Garnet Red ZL1 conve Drives: 2013 & 2018 ZL1 vert Join Date: May 2009 Location: Des Moines, IA Posts: 1,472 View My Garage	Parts removed for hydro-dipping Iv'e got my front end ready to remove the bumber so I can remove the lower splitter and send it to Fastlane (H2O Printers) to be hydro-dipped. Also removed my lower side skirts to be hydro=dipped. Fastlane is currently doing my rear lower valance right now and should be done late next week. I will of course take some pics when it arrives. I'm going to do some of my interior parts myself. I ordered the carbon fiber (mydipkit) and it looks really good on some test pieces I did. I also ordered some LED lights to install on the inside of my door handles to come on with the dome lights, I'll take pics of that also. Bill Attached Images __________________ Build Thread: 2018 ZL1 Vert Purchased (Overpar73)