Installed at 71 miles, now have 313. Seemed pretty easy, but (for me) nothing ever is.
I assembled the can first and attached it to the bracket. Then I took off the stock PCV line, not too bad after moving the bracket above the line (as suggested in the instructions). Next I placed the clamps on the hoses loosely (used the braided hoses) and installed the bottom first, then the top. It was difficult but doing it this way I was able to spin the hoses while pushing them onto the connectors. Got the hoses on as far as I could, then it took a lot of patience to tighten those clamps. When the clamps were tightened up, I attached the can and bracket in the appropriate location using a 10.9 grade bolt, 5mm longer than stock with washer to allow for the bracket being there. Finally I attached both hoses to the fittings on the can and done!
Pics show what I collected after 242 miles.
Installed.
Bolt.
I have some additional bolts/washers if anyone is interested. Glad I got this product, thanks Chase!